iopshark.blogg.se

Bmw e36 firing circuit driver airbag
Bmw e36 firing circuit driver airbag





bmw e36 firing circuit driver airbag
  1. #Bmw e36 firing circuit driver airbag install#
  2. #Bmw e36 firing circuit driver airbag code#

the end of the card will be flush with the unit casing with only the removal tape protruding.e.

#Bmw e36 firing circuit driver airbag code#

If ü û(Go Back) is pressed when either ‘nF’ or a fault code is displayed. Take care not to scratch the gold contacts.8.1. Once the initialisation is completed that card cannot be used in any other unit.

bmw e36 firing circuit driver airbag

Insert the application card into the slot in the bottom of the reset unit. 1 2 3 4 5 Vehicle VAG (VW/Audi/Seat/Skoda) Opel/Vauxhall Mercedes (Fast codes) Mercedes (Slow codes) BMW 5. If no faults are stored then ‘nF’ is displayed. 2 OPERATION Warning! Ensure that you read. The GM diagnostic connector socket (see below) is located in the passengerĬompartment fuse box or under a removable panel adjacent to the handbrake. The BMW 20 pin, diagnostic connector socket (see below) is located in theĮngine bay, normally along the bulkhead, but exact locations can vary. Read, understand and apply the safety instructions supplied with VS333. DO NOT use multimeters or test lamps etc.ĭisconnect all explosive devices before checking wiring with a multimeter. Use only diagnostic testers to diagnose faults. Connect welding ground as near to the work zone as possible.ĭo not expose systems to temperatures above 80☌. Remove airbag components when welding close to them. Switch off ignition and allow one minute for the system to discharge.ĭuring welding operations disconnect the vehicle battery.

#Bmw e36 firing circuit driver airbag install#

Store removed explosive devices in a locked area away from other hazardous materials.ĭo not install accessories in the area of the drive/passenger/side airbags.ĭo not connect or disconnect any wiring with the ignition “ON”. Observe component manufacturer’s instructions for safety, handling and installation. These include requirements on storage and transportation. Important! All work on vehicle restraint systems should be carried out by trained personnel.Įxplosive devices are subject to national laws which must be followed. The VS/AB Application Card, when used in conjunction with the Reset Unit from the VS333 Oil Service Reset KIt, provides airbag diagnostics for a wide range of vehicles.







Bmw e36 firing circuit driver airbag